Complete System can be purchased separately.

Our patented complete waste oil burning system with a universal burner mounting flange allows easy retrofit of our burner system to various configuration and sizes of combustion chambers. Initial flame adjustment is all that is needed with complete control thereafter.

Variably controlled, A/C converted, D/C gear motor driven waste oil pump. This Remote flow control pump supplies the exact gallons of oil per hour to each waste oil burning appliance, regardless of viscosity. This pump is to be located at oil supply tank and is capable of pushing 100's of feet to the used oil firing unit.

Continues the stabilization of the waste oil viscosity by holding oil and air temperatures that pass through it exact. Resulting in the most thorough and complete burn.
OIL HEATER BLOCK WILL NOT BUILD UP CARBON INSIDE ITS OIL PASSAGES!

OMNI is the only waste oil burner manufacturer who can say without equivocation it's oil preheater block absolutely will not carbon the oil internally due to its patented design. Therefore, the industry normal removal of carbon in the preheater block is not necessary. This design ensures that OMNI customers will never need to remove the burner for periodic carbon cleaning!

There are many who have easy access to their oil preheater block, but cleaning the hard lava-like carbon is not an easy task! Others request the entire burner be serviced at least annually. Part of that service is flushing their oil preheater block of carbon buildup. Some must do this more than others, as frequently as twice a season.

Fully cleaning and removing carbon is a difficult chore. Even after cleaning, carbon chunk particles can remain. Shortly after service, they can plug the oil nozzle, shutting the unit down. This causes a lot of down time and repeat service, not experienced with OMNI units.

Additionally, some manufacturers request their customers shut the unit down during the summer months to eliminate the carboning process. This is not necessary if the heater block assembly is Econo Heat's OMNI system. Just leave your unit on and it will automatically start by the thermostat when heat is needed. OMNI burners do no need to be torn apart to access the heater block for cleaning. These are a few of the operating proceedures COMPETITORS believes are standard; NOT WITH OMNI!

• Non-carboning oil heater block - cleaning not required
• A thorough burn - greatly reducing ash deposit accumulation
• Only system that can burn 90 weight oils
• Less stress on metals - can't overfire (After initial proper adjustment). No target burn-out
• Clean heater once a season under normal conditions
• The most reliable and consistent operation
• Greater efficiency